Rice Lake Combination System - Precision Loads PL9710 Indicator - Manual (Page 6)

Display Print, Select,
Zero, Select,
Menu
Key
Power
On/Off
Softkeys
(F1-F5)
Information
Display
Weight
or Up Key
or Down Key
2 PL9710 Installation Manual
1.2 Front Panel
Figure 1-1. PL9710 Front Panel
The
PL9710
indicator receives the digital signal from the transmitter and interprets and displays it as a weight in
pounds or kilograms. Two displays are used on the front of the indicator. The top LED display shows the weight of
the load and can easily be switched between truck, trailer, or total weight. The lower dot-matrix information
display complements the top display by showing the two non-displayed weights. For example, if the top LED
display is set to show the truck weight, the upper line of the information display will show the trailer weight and the
total weight. See Figure 1-1.
When the indicator is in the calibration or setup modes, the upper line of the information display will show a
calibration or setup message. The lower line will show the appropriate legend for the softkeys, F1 through F5. The
function of each of these keys changes depending on the mode that the
PL9710
is in. The labels will change as
various menus are selected during calibration or setup. See Table 1-1 for softkey definitions during normal
operation.
Table 1-1. Softkey Definition
Softkey Definition
F1 CH-1 Channel 1 or truck weight
F2 CH-2 Channel 2 or trailer weight
F3 TOT Total Weight
F4 AUTO - Auto cycle between CH-1, CH02, and Total