Rice Lake Combination System - Precision Loads PL9710 Indicator - Manual (Page 15)

PL9710 Installation Manual - Customer or Product ID and Load/Deliver 11
4. At any time between or after incremental loading
or delivering, the NET mode is accessible for
viewing the total net payload on the truck.
Press the
Net
softkey. The weight display will
show the total NET payload weight.
5. Press the
Print
key to print a paper ticket for the
load and, if the Accumulator function has been
enabled, the current load will be added to the
indicator’s internal memory for retrieval later.
For two-channel operation, make sure Load/Deliver
has been enabled. See “Advanced Setup” on page 22.
The indicator must be in TOTAL for Load/Deliver to
operate correctly. The Accumulator function is not
available.
1. Press the
Menu
key to get the Function Menu.
If you do not continue with the operation within
15 seconds, the indicator will reset to the normal
weighing mode and you will need to press the
Menu
key again.
2. Select Load/Deliver by pressing the
LD
softkey.
The red LED labeled LD at the left of the weight
display should be lit.
3. Select the customer or product ID by pressing the
ID
softkey.
The information display will briefly show Select
ID number and then show Select ID.
4. Press the
Up
or
Down
key for the appropriate
product or customer ID, then press the
Select
softkey.
5. Before picking up or delivering each load, press
the
Zero
key
6. Press the
Print
key to print a paper ticket for the
load.