Rice Lake Combination System - Precision Loads PL9710 Indicator - Manual (Page 26)

22 PL9710 Installation Manual
12.0 Advanced Setup
The Advanced Setup menu includes sub-menus for:
• Enabling the filter
• Selecting the channel mode (1 or 2 channels)
• Setting the number of load cells connected to the
indicator
• Enabling the load/delivery (LD) feature for
incremental weighing
• Enabling the lift-to-weigh feature for tipping
operations
• Enabling the cal
• Enabling the accumulator to store up to 100
weighing events
The sections for the sub-menus in this chapter are written to be independent of each other. If you wish to use more
than one of the sub-menus, press the
Cancel
softkey only once at the end of the selection sequence. Then use the
Up
or
Down
key to select another sub-menu. Pressing the
Cancel
softkey twice will return the indicator to normal
operation.
12.1 Enabling the Filter
When the filter is enabled, the indicator will average 2,
4, or 8 data samples before displaying the weight.
Using the filter will stabilize the display (numbers will
not bounce around as much) but the display will be
slower to update.
1. Press the
Menu
key for about 12 seconds until the
information display shows Advanced Setup
Menu.
After releasing the
Menu
key, the information
display will show Setup selection and the weight
display will show Setup.
2. To select the Filter submenu, press the
Up
key
until the information display shows Filter: None.
3. Press the
More
softkey or
Less
softkey to decrease
filtering.
4. Press the
Cancel
softkey to return to the submenu
selection.
5. Press the
Cancel
softkey again to exit Advanced
setup and return to normal operation.
12.2 Selecting the Number of Load Cells
Per Channel
1. Press the
Menu
key for about 12 seconds until the
information display shows Advanced Setup
Menu.
2. After releasing the
Menu
key, the information
display will show Setup selection and the weight
display will show Setup.
3. To select the Number of Load Cells submenu,
press the
Up
key until the information display
shows Number of Load Cell Ch1=2.
4. Press the appropriate key to select the number of
load cells that are connected to Channel 1.
5. Press the
Cancel
softkey and then the
Up
key for
Channel 2.
The information display will show Number of
Load Cell Ch2=2
6. Repeat Step 4 to select the number of load cells
that are connected to Channel 2.
7. Press the
Cancel
softkey to return to the submenu
selection.
8. Press the
Cancel
softkey again to exit Advanced
Setup and return to normal operation.
12.3 Enabling Load/Delivery
1. Press the
Menu
key for about 12 seconds until the
information display shows Advanced Setup
Menu.
2. After releasing the
Menu
key, the information
display will show Setup selection and the weight
display will show Setup.
3. To select the Load/Delivery submenu, press the
Up
key until the information display shows
Enable Load/Delivery YES.
4. Press the appropriate softkey for
Yes
or
No
.
5. Press the
Cancel
softkey to return to the submenu
selection.
6. Press the
Cancel
softkey again to exit Advanced
Setup and return to normal operation.
12.4 Enabling Lift-to-Weigh
1. Press the
Menu
key for about 12 seconds until the
information display shows Advanced Setup
Menu.
2. After releasing the
Menu
key, the information
display will show Setup selection and the weight
display will show Setup.
3. To select the Lift to Weigh submenu, press the
Up
softkey until the information display shows
Enable Lift to Weigh: Yes.
4. Press the appropriate softkey for
Yes
or
No
.
5. Press the
Cancel
softkey to return to the submenu
selection.
6. Press the
Cancel
softkey again to exit Advanced
Setup and return to normal operation.