Rice Lake 920i Installation Manual V1.05 - Manual (Page 53)

Print Formatting 49
6.2 Default Print Formats
Table 6-2 shows the default print formats for the 920i and lists the conditions under which each print format is
used. The HDRFMT1 and HDRFMT2 formats are used to specify header information that can be used by the
other ticket formats. The contents of the HDRFMT
x format can be inserted into any other ticket format using the
6.3 Customizing Print Formats
The following sections describe procedures for
customizing print formats using the
iRev conÞguration
utility, serial commands, or the front panel (PFORMT
menu. See Section 10.5 on page 91 for information
about custom stream formatting.
6.3.1 Using iRev
The iRev conÞguration utility provides a ticket
formatting grid with a tool bar. The grid allows you to
construct the ticket format without using the
formatting commands ( and ) required by
the front panel or serial command methods. Using
iRev , you can type text directly into the grid, then
select weight value Þelds from the tool bar and place
them where you want them to appear on the printed
ticket.
Figure 6-1 shows an example of the iRev print
formatting display.
Figure 6-1. iRev Print Formatting Display
Format Default Format String Used When
GFMT GROSS Normal mode, no tare in system
NFMT GROSSTARENET
Normal mode, tare in system
ACCFMT ACCUM Accumulator enabled and displayed, or
setpoint print operation with PSHACCM=ON
SPFMT Setpoint print operation with PSHPRNT=ON
TRWIN IDGROSS
Press the Weigh In softkey, enter truck ID
number, and press
enter .
TRWOUT IDGROSSTARE>NET Press the Weigh Out softkey, enter truck ID
number, and press
enter .
TRFMT REG ID: : SCALE Truck register currently displayed
HDRFMT1
HDRFMT2 COMPANY NAMESTREET ADDRESS
CITY, ST ZIP Must be inserted into other print format
AUXFMT GROSS Access only through iRite programming
NOTE: In OIML and CANADA modes, the letters PT (preset tare) are automatically inserted after the printed tare weight.
Table 6-2. Default Print Formats