Rice Lake 920i Installation Manual V1.05 - Manual (Page 38)

34 920i Installation Manual
KYBDLK OFF
ON Keyboard lock. Specify ON to disable the keypad in normal mode.
ZERONLY OFF
ON Zero key only. Specify ON to disable all front panel keys except ZERO in normal mode.
PROMPTS PROMPT1–
PROMPT60 Specify prompts for use in setpoint names. Prompts are referenced by the NAME
parameter under the SETPTS submenus; prompts are shown on the display during setpoint
execution.
REGULAT NTEP
CANADA
NONE
OIML Regulatory mode. Specifies the regulatory agency having jurisdiction over the scale site.
• OIML, NTEP, and CANADA modes allow a tare to be acquired at any weight greater
than zero. NONE allows tares to be acquired at any weight value.
• OIML, NTEP, and CANADA modes allow a tare to be cleared only if the gross weight is
at no load. NONE allows tares to be cleared at any weight value.
• NTEP and OIML modes allow a new tare to be acquired even if a tare is already
present. In CANADA mode, the previous tare must be cleared before a new tare can be
acquired.
• NONE, NTEP and CANADA modes allow the scale to be zeroed in either gross or net
mode as long as the current weight is within the specified ZRANGE. In OIML mode, the
scale must be in gross mode before it can be zeroed; pressing the ZERO key in net
mode clears the tare.
The value specified for this parameter affects the function of the front panel TARE and ZERO
keys. See Section 10.2 on page 90 for a complete description of TARE and ZERO key
functions for each of the regulatory modes.
REGWORD GROSS
BRUTTO Sets the term displayed when weighing in gross mode. Selecting BRUTTO replaces the
Gross annunciator with Brutto.
LOCALE OFF
ON Locale. Set this parameter ON to enable the LATUDE and ELEVAT parameters. Specifying
latitude and elevation of the scale site provides compensation for gravitational effects.
Attached scales must be recalibrated after changing this parameter from OFF to ON.
LATUDE 45
0–90 Latitude. Specify the latitude of the scale site in degrees. This parameter is shown only if
LOCALE=ON.
ELEVAT 345
±0–9999 Elevation. Specify the elevation of the scale site in meters. Valid values are –9999 through
9999. This parameter is shown only if LOCALE=ON.
Level 3 submenus
DATEFMT MMDDYYYY
DDMMYYYY
YYYYMMDD
YYYYDDMM Specifies the format used to display or print the date.
DATESEP SLASH
DASH
SEMI Specifies the date separator character.
TIMEFMT 12HOUR
24HOUR Specifies the format used to display or print the time.
TIMESEP COLON
COMMA Specifies the time separator character.
FEATURE Menu
Parameter Choices Description
Table 3-6. FEATURE Menu Parameters (Continued)