Oldcastle BuildingEnvelope Reliance StormMax High Performance - Manual (Page 8)

February 2014 06-Jamb-Fabrication 1-866-Oldcastle (653-2278) www.oldcastlebe.com
HW-202-01 Anchor Sleeve
HW-710 Jamb Mullion
HW-185-01
Shear Block
(4) FS-9
Fasteners
(2) FS-320 Drive Screw
HW-348 Jamb End Cap
Apply sealant bed to entire
length of Jamb Mullion
HW-123 Jamb Filler
FS-322
Fastener
locate 12" O.C.
1.2 a. Prior to HW-185-01 shear block attachment insert HW-202-01 Anchor Sleeves at Jamb ends and match
drill .191 dia. hole.
b. Attach HW-185-01 shear block to HW-710 Jamb with FS-9 fastener.
c. Attach HW-123 Jamb Filler to HW-710 Jamb using FS-322 Fastener locate 12" O.C. (Drill #11 - .191"
clear hole in HW-123 Jamb Filler and #25 - .1495" pilot hole in Jamb) HW-123 Filler should be bed
in sealant. Tool sealant on gap space between HW-123 Filler and Jamb Mullion.
d. Install interior FG-5185 Spacer Gasket cut to 2" from ends and 2" gaps at horizontal to allow for
zone plugs. (Not applicable for Dry Glazed applications.)
e. Install, seal and tool HW-348 End Caps to top and bottom of Jamb screw boss with
(2) FS-320 #10 x 1/2" drive screws.
Apply sealant bed to entire front
edge of mullion end prior to
installation of HW-348 Jamb Cap
2"
Gap dimension for
HW-355 Zone Plug
FIGURE 1.2
JAMB FABRICATION
Apply sealant bed to
entire edge of mullion
end prior to installation
of HW-348 Jamb Cap
RELIANCE STORMMAX HIGH PERFORMANCE INSTALLATION MANUAL