Oldcastle BuildingEnvelope Reliance-TC - Manual (Page 35)

TRANSITION GLAZING
R E L I A N C E - T C C U R T A I N W A L L I N S T A L L A T I O N M A N U A L TM
FIGURE 34
Installing Glazing Adaptors
WW-145
Vertical
Horizontal
WW-130
1
2
1
2
Seal adaptors at joint
(Marry at groove)
Seal Groove
(Marry at corners)
FIGURE 35
Sealing Glazing Adaptors
Adaptor installation at AW vertical
mullions and horizontals.
MAY 2013 35
Phone: 1-866-OLDCASTLE (653-2278)
Web Address: www.oldcastlebe.com
A.1 Install vertical adaptors first, leaving an equal overlap into each pocket. SEE FIGURE 34. Refer to
VERTICAL SPLICING, page 37 if vertical mullion is spliced within a spandrel lite. Transition adaptors must be
installed after mullion splice is sealed.
A.2 Install horizontal adaptors maintaining an equal gap at each end. Once all adaptors have been installed in the
opening, seal all corner joints. Run a bead of sealant in the groove formed between the adaptor and mullions. This
seal must be continuous around the opening and must marry with the seal at the corner joints. SEE FIGURE 35.
Note: Alternate glass thickness not available for the high performance Reliance-TC system. This product is designed
for 1" glazing with optional triple glaze available.