Oldcastle BuildingEnvelope Reliance-TC - Manual (Page 33)

CORNER ASSEMBLY
R E L I A N C E - T C C U R T A I N W A L L I N S T A L L A T I O N M A N U A L TM
FIGURE 32
OS90 Corner Assembly
Ho
riz.
C
ut
Len
gt
h
MAY 2013 33
Phone: 1-866-OLDCASTLE (653-2278)
Web Address: www.oldcastlebe.com
4.3 Attach AW-181-01/02 shear blocks to mullion using (2) FS-9 #14 x 1 1/2" HH STS. Horizontal to
be mitered at 45 degrees from edge of vertical as shown in FIGURE 32.
4.4 Install AW-309 zone plug into pocket prior to installing pressure plate. Bed zone plug in sealant and
run bead around zone plug and tool to form water tight seal. Just before installing pressure plate run bead
along face of zone plug and press gasket and pressure plate into this seal.
4.5 In vision areas use either WW-220 or CW-823 interior trim to close off back of corner mullion.
4.6 If corner is being installed in multi-span application use AW-129-01 splice and follow splice
instructions on pages 36-37.
WW-115 Face Cap
WW-162 Pressure Plate
FS-325 @ 9" O.C.
AW-129-01 Splice
AW181-01 (R)
AW-181-02 (L)
FS-9 Fasteners
AW-309 Zone Plug