Kontron SMARC-sAT30 - Manual (Page 8)

User’s Guide
www.kontron.com 8
2 Introduction
The SMARC® (Ultra Low Power – Computer on Module) sAT30 is a versatile small form factor Computer-On-Module
that requires low power and provides high performance at low cost. The module connector has 314 edge fingers that
mate with a low profile 314 pin 0.5mm pitch right angle connector (this connector is sometimes identified as an 321
pin connector, but 7 pins are lost to the key).
Featuring NVIDIA’s Tegra T30 System-on-Chip, Kontron’s SMARC sAT30 offers LVDS, Parallel LCD, HDMI Display,
Gigabit Ethernet, PCIe, SATA, USB, USB OTG, Camera support and superior graphics performance in a cost effective, low
power, miniature package. Kontron’s SMARC sAT30 thin and robust design makes it an ideal building block for
reliable system design.
Caution! The SMARC sAT30 module is ESD sensitive equipment. Users must observe precautions for handling
electrostatic discharge sensitive devices.
2.1 Feature Set Overview
» SMARC compliant in an 82mm x 50mm form factor.
» NVIDIA Tegra 3 quad-core ARM Cortex A9 SoC
» Up to 1.3GHz operation (Quad core operation, restricted temperature range).
» Up to 1.2 GHz operation (Quad core, over 0 – 60 °C temp range, with appropriate heat sink).
» Up to 1.4 GHz operation (Single core mode).
» Up to 2GB of DDR3 SDRAM support.
» On-board NAND flash (eMMC) support up to 64GB.
» On-board Intel I210 (Springville) GbE controller.
» Single channel 18bit LVDS display support (24 bit / 18 bit compatible as well).
» 24 bit parallel LCD display support.
» HDMI output.
» 1.8V Module I/O support.
» GPIO support.
» SDIO support.
» I2S support.
» I2C support.
» Two Serial Camera interfaces (CSI).
» Two PCIe ports.
» USB and USB (On-The-Go®) OTG support.
» Watch Dog Timer (WDT) support.
» UART support.
» SATA support.