3 examples of sconf command usage, 1 sconf select, 2 sconf set – Kontron COMe-bP5020 User Manual
Page 57: Examples of sconf command usage, Sconf select, Sconf set

www.kontron.com
57
User Guide
COMe-bP5020
6.5.3 Examples of sconf Command Usage
6.5.3.1 sconf select
To change the setting, invoke the “sconf select” command.
Example:
6.5.3.2 sconf set
The setting of the chosen base configuration can be changed via the “sconf set” command. If the “sconf set” command is in-
voked without parameters, all changeable options are shown. In the following example, first, all possible settings are shown,
and then the SDHC routing is changed from onboard to external.
After each “sconf select” or “sconf set” a system powercycle must be performed.
=> sconf select 2
New base configuration 2
=>
=> sconf set
Board's Port Configuration for base config 3 (serdes protocoll 0x15):
Option/Setting | Value # command option
---------------+--------+------------------------------------
PCIe1 : @5.0G # sconf set pcie1 <@5.0G | @2.5G | off>
PCIe2 : @5.0G # sconf set pcie2 <@5.0G | @2.5G | off>
Aurora : off # sconf set aurora
XAUI : on # sconf set xaui
SATA1 : on # sconf set sata1
SATA2 : on # sconf set sata2
USB : host # sconf set usb
UART : 4wire # sconf set uart <4wire | 2wire>
SDHC : onb # sconf set sdhc
GPIOA : gpio # sconf set gpioa
GPIOB : gpio # sconf set gpiob
GPIOC : gpio # sconf set gpioc
=> sconf set sdhc ext