Kontron AT8402 User Manual - Manual (Page 74)

AT8402 Software Description
Page 4 - 10 AT8402 User Guide
The AT8402 management controller supports sensor devices and uses the IPMI dynamic sen-
sor population feature of IPMI v1.5 to merge the AMC hot swap sensor with the AT8402 sen-
sors population. AMC hot swap events indicated by this sensor are passed to the ShMC.
Additionally, the IPMC updates the sensor population change indicator timestamp accessible
through the Get Device SDR Info command to remain compliant to IPMI v1.5.
All SDRs can be queried using Device SDR commands. Base Board sensors that have been
implemented are listed below.
Table 4-3: AT8402 sensors
IPMI Sensor Name Unit Health LED/Sensor
IpmC Reboot discrete no change
IPMI Watchdog discrete no change
IPMC Storage Err discrete no change
SEL State discrete no change
FRU0 Reconfig discrete no change
EventRcv ComLost discrete no change
IPMI Info-1 discrete no change
IPMI Info-2 discrete no change
IPMB0 Link State discrete no change
FRU0 IPMBL State discrete no change
FRU1 IPMBL State discrete no change
FRU2 IPMBL State discrete no change
FRU3 IPMBL State discrete no change
FRU4 IPMBL State discrete no change
FRU0 FRU Agent discrete no change
FRU1 FRU Agent discrete no change
FRU2 FRU Agent discrete no change
FRU3 FRU Agent discrete no change
FRU4 FRU Agent discrete no change
FRU0 Hot Swap discrete no change
FRU1 Hot Swap discrete no change
FRU2 Hot Swap discrete no change
FRU3 HotSwap discrete no change
FRU4 HotSwap discrete no change
Firmware Upg Mng discrete no change
Health Error discrete no change
Temp Air Inlet degrees C Exceeds critical threshold
Temp Air Outlet degrees C Exceeds critical threshold
Temp SAS Contr. degrees C Exceeds critical threshold