Kontron AT8402 User Manual - Manual (Page 62)

AT8402 Hardware Description
Page 3 - 29 AT8402 User Guide
The following table shows the assignment between connector position and switch port (CLI ID).
The two lower RJ45 connectors of the 4-fold block are unused.
The LEDs are controlled by the CPLD: Link/ Activity (Green) and Speed (Green/Yellow).
3.2.4 SAS/SATA Channels
An external 4x SAS/SATA connector provides access to the AT8402 SAS Expander device.
The connector is a SFF-8470 fixed (receptacle) shielded connector with jack screws.
Table 3-26: GbE Assignment
Switch Port Connector
0/1 GE1
0/2 GE2
Table 3-27: GbE LEDs Signification
Speed LED (Green/Yellow)
GREEN 1000BASE-T
YELLOW 100BASE-TX
OFF 10BASE-T
Status LED (Green)
OFF Link down
ON Link up and no activity
BLINK Link up and activity
Table 3-28: External 4x SAS Connector Pin Assignment
Pin
Number
Signal Driven by
G1-G9 Ground -
S1 STOR0_RX+ RTM
S2 STOR0_RX -
S3 STOR1_RX +
S4 STOR1_RX -
S5 STOR2_RX+
S6 STOR2_RX -
S7 STOR3_RX +
S8 STOR3_RX -