Kontron AT8402 User Manual - Manual (Page 19)

AT8402 Introduction
Page 1 - 5 AT8402 User Guide
1.1.2 General compliances
The AT8402 is conform to the following specifications:
• PICMG 3.0 AdvancedTCA Base Specification, Revision 2.0
• PICMG 3.1 Ethernet/Fibre Channel for AdvancedTCA Systems
• AMC.0 Advance Mezzanine Card Base Specification, Revision 2.0
• AMC.1 PCI Express and Advanced Switching
• AMC.2 AMC Gigabit Ethernet
• AMC.3 AMC Storage
• IPMI v1.5 Intelligent Platform Management Interface Specification
• PCI Express 1.0a
1.1.3 Optional Accessories
1.1.3.1 AMC
Up to four mid-size single width or up to two mid-size double width AMC bays for standard or
custom AMCs are implemented.
AMC slots can be equipped with a:
• Processor-AMC
• HDD-AMC as mass storage device for the Processor-AMC
• Interface AMC, e.g. Quad GbE
1.1.3.2 RTM
The Kontron RTM8400 provides additional GbE switch ports and out-of-band management ac-
cess via Fast Ethernet. Two GbE uplinks and an external 4x SAS connector are also provided.
For further information on the RTM8400, refer to section 3.2 of this document.
1.1.4 Hot Swap Capability
The board supports Full Hot Swap capability is required by PICMG 3.0 R1.0. It can be removed
from or installed in the system while it is on (without powering-down the system). Please refer
to the PICMG 3.0 R1.0 specification for additional details.