Kontron AT8402 User Manual - Manual (Page 31)

AT8402 Installation
Page 2 - 6 AT8402 User Guide
1. Connect to serial port on the front plate (using the provided adaptor cable) or RTM (using
a RJ45 straight cable).
Port settings are:
• 9600 bps
• 8 bit, no parity, 1 stop bit (8N1)
• no flow control
2. Ensure that the board is powered up.
3. Wait for boot process to complete, i.e. until the console selection menu appears.
b - connect Base Fabric console
r - reset system
4. Type ’b’ to connect to the Base Fabric console.
Connected to Base Fabric console
Press ^X or ^V to get to menu again
Base Fabric switching application release BETA 1.04 starting
(Unit 1)>
User:
5. Log in as admin and enter privileged mode by typing ’enable’ (no passwords required by
default).
User:admin
Password:
(Ethernet Fabric) >enable
Password:
(Ethernet Fabric) #
6. Set IP address and netmask. (see below for an example IP address setting)
(Ethernet Fabric) #serviceport ip 192.168.50.107 255.255.255.0
The FE management interface is available from now on.
7. Save configuration by copying it to the flash, confirm by typing ’y’
(Ethernet Fabric) #copy system:running-config nvram:startup-config
This operation may take a few minutes.
Management interfaces will not be available during this time.
Are you sure you want to save? (y/n) y
Configuration Saved!
(Ethernet Fabric) #
To access the CLI via Fast Ethernet management port, open a telnet connection to the config-
ured IP address, port 23.
For additional information on the system configuration, refer to the “AT8402 CLI Reference
Manual“.