6 updating the pld, 7 using diagnostics, 6 updating the pld 5.7 using diagnostics – Kontron AT8940 User Manual
Page 70
Software Setup
55
www.kontron.com
5.6
Updating the PLD
Updating the FPGA data is done with the "copy" command.
The update package for the FPGA will be delivered as a tar-file and is stored in the data/update path of the
release directory tree.
(BASE Ethernet) #copy tftp://192.168.50.5/t5310-fpga-BETA-1.02.tar pld
Mode........................................... TFTP
Set Server IP.................................. 192.168.50.5
Path........................................... ./
Filename....................................... t5310-fpga-BETA-1.02.tar
Data Type...................................... FW Update
Destination Filename........................... pld
Management access will be blocked for the duration of the transfer
Are you sure you want to start? (y/n) y
TFTP Firmware transfer starting...
Firmware update successful...
(BASE Ethernet) #
5.7
Using diagnostics
Diagnostics-software is stored in a separate tar-file which is provided with each release and must be loaded
separately, e.g.
(BASE Ethernet) #copy tftp://192.168.50.5/test-diag.tar backup
Mode........................................... TFTP
Set Server IP.................................. 192.168.50.5
Path........................................... ./
Filename....................................... tes-diag.tar
Data Type...................................... Code
Destination Filename........................... backup
Management access will be blocked for the duration of the transfer
Are you sure you want to start? (y/n) y
TFTP Code transfer starting...
Write image to flash starting...
File transfer operation completed successfully.
(BASE Ethernet) #