ETS-Lindgren 2181 Turntable - Manual (Page 9)

Introduction | 9
The IR remote communicates with an infrared receiver in the Model 2181
motor base through an IR repeater installed in the floor near the turntable. See
IR Repeater Installation on page 23 for instructions on installing an IR repeater.
S LIP R ING
Allows continuous rotation of the turntable through the latest technology in
mercury slip rings, and either Schuko or NEMA connectors can be ordered with
the slip ring. The current rating for the standard electrical assembly is
20 amperes. Contact ETS-Lindgren for custom requirements on slip rings.
EUT P OWER O UTLETS
Receptacles are usually mounted on the base of the turntable at the center axis
point. These receptacles can be custom mounted, flush with the tabletop on
some turntables. Contact ETS-Lindgren for information.
M OUNTED L INE I MPEDANCE S TABILIZATION N ETWORK
A Line Impedance Stabilization Network (LISN) can be mounted to the underside
of some turntables. This option is only practical on larger turntables with sufficient
clearance.