Elecraft K3-Remote Owner's Manual - Manual (Page 13)

13
9. Check or enter the following data in the Radio Settings window. Note that some are selected using drop-
down menus:
Program Mode 14 - Elecraft K3 twin
Sip Password (Optional: No entry required)
Sip Contact (Enter the Public IP or Domain Name of your
remote site station. Default: 192.168.1.170)
Auto Connect No
Audio Quality 3 – aLaw 12 kHz
Codec Out Gain 250
Codec Inp Gain 32
Codec Inp preamp
Codec Inp attenuation
163
Yes
Com0 baudrate 38400
Com0 data bits 8
Com0 parity 0 - off
Com0 program mode 3
char timeout 2
Use USB Com port as
Com0 No
Note: If you want to customize any of these settings, refer to the RemoteRig
manual at
www.remoterig.com .
10. When all the above entries are complete, click on the button and then on the
button when it appears. You will see the message “Settings saved, restarting
device” appear in the window. You can click on the Radio button on the side menu to reinstate the
screen showing all the settings to confirm that the changes were made properly.
11. Disconnect the RRC-1258 unit from power and your LAN and connect the RRC-1258 remote site unit
(the one without the CW knob) to the power supply and LAN.
12. Enter the I.P. address of the RRC-1258 unit on the browser’s address bar to open the Microbit program
window. Unless you changed it in step five, the I.P. address is 192.168.1.170.
13. Click on Radio to open the Radio settings window for the remote site RRC-1258 unit. Set Audio Dual-
RX as follows:
 No: mixes the two audio channels (when separate channels present) so the same audio is heard in
each earphone.
 Yes: provides stereo audio, for example to listen to the sub receiver in the remote site K3 in one
earphone and the main receiver in the remote site K3 in the other earphone. Note: This setting
doubles the bandwidth required for communications between the control and remote RRC-
1258. This may exceed that available in some DSL internet connections.