Elecraft K3-Remote Owner's Manual - Manual (Page 12)

12
7. Disconnect the USB cable between and connect both the RRC-1258 control site unit with the CW knob
and the computer to your LAN (Figure 8). Note that the PWR light on the RRC-1258 unit’s front panel
stops blinking and remains on, indicating communications with the router. If it continues to blink, check
to ensure the cable connectors are fully inserted and that you have a good cable. You must have a steady
green PWR light to proceed.
Figure 8
8. Open your computer browser and enter the I.P. address of the RRC-1258 unit on the browser’s address
bar to open the Microbit program window shown in Figure 9. Unless you changed it in step five, the I.P.
address is 192.168.1.169. Click on Radio in the left menu to open the screen shown.
Figure 9