Elecraft KXAT100 Installation Manual - Manual (Page 8)

8
Disconnect all cables from your KXPA100 and place it upside down, resting on the heat sink fins, on your
work table.
All of the screws that you will remove are identical and interchangeable. Also, they are
the same length as the screws you got with the KXAT100. Take care to save all of them and
the other hardware you remove to reassemble the amplifier.
Remove the four corner feet. Each foot is held in place with six screws, spacers and lock washers.
Remove three screws, spacers and lock washers on the side as shown in Figure 1and slide the foot off of
the other three screws, spacers and lock washers at the end panel.
Figure 1. Removing the Feet.
Remove the six screws, lock washers and spacers to free the front panel and lift it off. Take care not to lose
the lock washers or spacers on each screw. Set the panel aside. It will be replaced with a new front panel later.
Figure 2. Removing the Front Panel.