Bulb gasket installation, Step 1), Fig. # 60 – EFCO 960 Series User Manual

Page 57: Fig. # 58

Text mode
Original mode

gasket into the sealant. Refer to the figures below.

Apply sealant in the glazing bulb cavity 1" from the ends, and push the bulb

(D.C. 795)

SILICONE TYPE SEALANT

Push in all VERTICAL glazing gasket, being careful not to stretch the gasket.

STEP 1)

FIG. # 60

horizontals and verticals.

1" from the ends of all

Set bulb in sealant

FIG. # 58

TYP.

the gasket.

Push the bulb
in being careful
not to strech

PAGE 55

JDA 10/2000

SECTION VIII G -

SCREW SPLINE / SHEAR BLOCK

BULB GASKET INSTALLATION

Push in all HORIZONTAL glazing gasket, being careful not to stretch the gasket.
Apply sealant in the glazing bulb cavity 1" from the ends, and push the bulb
gasket into the sealant. Refer to the figures above.

STEP 1)

GASKET SHOWN
INSTALLED