EFCO 960 Series - Manual (Page 3)

PAGE 1
SECTION I - GENERAL NOTES
common conditions.
engineered part of the system.
1)
to begin installation.
2)
3)
4)
No abrasive agent should be used.
5)
6)
7)
Clean all finished aluminum surfaces with a mild detergent and water.
solutions, and acid based materials can be harmful to the finish.
Protect aluminum materials after erection. Cement, plaster, alkaline
All materials are to be installed plumb, level, and true.
Sealants must be compatible with all surfaces. Consult with the sealant
manufacturer for recommendations regarding compatibility and adhesion.
Check construction for compliance with the contract documents.
established by the architectural drawings and the general contractor.
All work should start from bench marks and/or column center lines as
(See Section II "PARTS IDENTIFICATION")
Check all materials upon arrival and be sure you have everything required
exterior glazed with either 1/4" or 1" dry glazing. Entrance doors are an
and has system depth dimensions from 2 3/4" to 8 1/8". The system is
EFCO Series 960 Wall is a thermal wall system with a 1 3/4" face dimension
The installation instructions are of a general nature and cover the most
drawings take precedence and include specific details for the project.
Check the shop drawings, installation instructions, and the glazing
instructions to become thoroughly familiar with the project. The shop
JDA 10/2000