Dynojet 424 Linx: DWRT Installation Guide User Manual
Page 30
Linx Installation for Model 424 Automotive Dynamometers
4 2 4 L I N X I N S T A L L A T I O N
Pulley Mounting Plates and Outer Bearings Installation
26
I
NSTALLING
THE
S
TATIONARY
D
YNO
P
ULLEY
O
UTER
B
EARING
, B
EARING
M
OUNTING
P
LATE
,
AND
L
OWER
P
ULLEY
M
OUNT
1
Secure the outer stationary dyno pulley bearing to the stationary dyno pulley
bearing plate using four 9/16-12 x 2-inch bolts, four 9/16-inch flat washers, and
four 9-16-inch nuts. Slide this assembly onto the stationary dyno pulley outer
shaft.
Figure 23: Install the Outer Stationary Dyno Pulley Bearing and Bearing Plate
2
Place a lower stationary dyno pulley mount (P/N 61300023) under the stationary
dyno pulley and loosely secure the mount to the inner plate using
five 3/8-16 x 1-inch bolts and five 3/8-inch flat washers (one of the holes on the
pulley mount is not used).
3
Loosely secure the pulley mount to the stationary dyno pulley bearing plate using
five 3/8-16 x 1-inch bolts and five 3/8-inch flat washers.
Figure 24: Secure the Pulley Mount Under the Stationary Dyno Pulley
XD061
stationary dyno
pulley bearing
stationary dyno
pulley bearing plate
stationary dyno
pulley
XD062
pulley mount
P/N61300023
stationary dyno
pulley bearing plate