Dynojet 424 Linx: DWRT Installation Guide - Manual (Page 24)

Linx Installation for Model 424 Automotive Dynamometers
4 2 4 L I N X I N S T A L L A T I O N
Pulley Mounting Plates and Outer Bearings Installation
20
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
PULLEY MOUNTING PLATES AND OUTER BEARINGS INSTALLATION
Note: The inner pulley mounting plates and the pulley mounts are stamped with
numbers to help match the parts and guide you in the installation process.
You will need the following parts:
• 21200083 Stationary Dyno Pulley Bearing Mounting Plate
• 21200090 Moveable Dyno Pulley Bearing Mounting Plate
• 21200091 Idler Pulley Bearing Mounting Plate
• 32300001 Flange Bearing with Lock Collar (3)
• 36711100 Nut, 9/16-12, Hex (12)
• 36811640 Bolt, 9/16-12 x 2", Hex (12)
• 36900001 Washer, 1/4", Lock (4)
• 36923100 Washer, 3/8", Flat (60)
• 36943101 Washer, 9/16", Flat (12)
• 61300022 Pulley Mount, Upper, Stationary Dyno
• 61300023 Pulley Mount, Lower, Stationary Dyno (3)
used for stationary dyno pulley, lower
moveable dyno pulley, upper
idler pulley, lower
• 61300025 Pulley Mount, Upper, Idler Pulley
• 61300026 Pulley Mount, Lower, Moveable Dyno
• DM150-019-012 Bolt, 3/8-16 x 1", Hex (60)