Dynojet 424 Linx: DWRT Installation Guide - Manual (Page 28)

Linx Installation for Model 424 Automotive Dynamometers
4 2 4 L I N X I N S T A L L A T I O N
Pulley Mounting Plates and Outer Bearings Installation
24
3 Place the upper moveable dyno pulley mount (P/N 61300025) over the idler
pulley and loosely secure the mount to the inner plate using five 3/8-16 x 1-inch
bolts and five 3/8-inch flat washers.
4 Loosely secure the pulley mount to the idler pulley bearing plate using
five 3/8-16 x 1-inch bolts and five 3/8-inch flat washers.
5 Loosely secure the pulley mount to the movable dyno pulley bearing plate using
two 3/8-16 x 1-inch bolts and two 3/8-inch flat washers.
6 While applying upward pressure to support the shaft and pulley, tighten all the
bolts.
Figure 21: Secure the Pulley Mount Over the Idler Pulley
XD060
pulley mount
P/N 61300025