beautypg.com

Step 5- installing the turbo/oil tank assembly – BoonDocker POLARIS: 2007-10 Dragon Pump Gas User Manual

Page 8

background image

BoonDocker Performance 1585 Hollipark Dr. Idaho Falls, ID 83401

Toll Free (US) 877-552-6127 or 208-542-4411 www.boondockers.com

Revised 10/01/2010

Page 8

Step 5- Installing the Turbo/Oil Tank Assembly

Parts Needed

Tools Needed

Turbo/Oil Tanks Assembly Kit

Basic Tools

Drill

3/16” Drill Bit

5/16” Drill Bit

Hammer

A. For the 800 model bend the tab on the factory exhaust muffler bracket toward the engine flush
with a hammer and then trim the outside of the exhaust bracket to remove spring tabs as shown in
picture.

B. For the 600 and 700 models you will have to bend the tabs toward the engine on the factory
exhaust muffler bracket to allow the Boondocker Oil tank to sit flush and trim off the front outer
spring tab.

C. Line up the new oil tank with bulk head.
The oil tank should be tight to the
bulkhead and slid all the way forward.
Install backing plate below resonator
bracket with F to the front of the sled and
tighten using supplied hardware.