BoonDocker POLARIS: 2007-10 Dragon Pump Gas - Manual (Page 18)

BoonDocker Performance 1585 Hollipark Dr. Idaho Falls, ID 83401
Toll Free (US) 877-552-6127 or 208-542-4411 www.boondockers.com
Revised 10/01/2010 Page 18
Tools Needed: Parts Needed:
Basic Tool Set Boondocker air filter w/ pre-filter
two size 52 clamps
Installing Air Filter
A. Fasten the air filter in place with the provided size 52 clamps. Note you may have to trim the
provided rubber coupler.
Filling Oil Tank
A. We recommend using Polaris VES Gold 2 cycle oil for your turbo. Fill the Boondocker Oil tank to
the full line on the dipstick. There are two lines, a full line and an add line. Fill with approximately
16 oz of oil to reach full line.
Important: Before running your sled you must make sure the oil pump is working properly see
next page for details.
Check the oil pump to make sure it is pumping
A. Fill the Boondocker oil tank with Polaris VES Gold 2 cycle oil.
B. Remove the oil inlet fitting from the turbo. Have
the quart or a container ready to catch the oil after
starting the sled.
C. Have someone hold the oil line over the container
and hold the fins on the inside of the turbo so they
won’t spin (Do not rev up the sled while holding
the fins). Start the sled. It might take 10-20
seconds for the oil to fill the lines. If the pump does
not work go back and make sure you have oil in the
machine and then check to make sure you are
getting power to the pump.
D. After verifying the pump is working, re-install the oil inlet to the turbo.
Boondocker Recommends Changing The Stock Spark Plugs To NKG Iridium IX BR9EIX.