BoonDocker POLARIS: 2007-10 Dragon Pump Gas - Manual (Page 17)

BoonDocker Performance 1585 Hollipark Dr. Idaho Falls, ID 83401
Toll Free (US) 877-552-6127 or 208-542-4411 www.boondockers.com
Revised 10/01/2010 Page 17
Tools Needed: Parts Needed:
Rivet Gun (6) 3/16” rivets
Drill
10 Rivet Washers
3/16” Drill Bit
A. Tip the sled on its side and remove the existing
rubber grommet from the factory exhaust outlet
hole.
B. Place the block off plate over the outlet hole. Set
your first rivet in the existing hole as shown. Be
sure to place a rivet washer on the back side of the
rivet and then rivet in place. Note: you can also
use silicone for a more water proof seal.
C. Drill the remaining 6 holes with a 3/16” drill
bit.
D. Rivet the remaining 9 holes but be sure to set
rivet washers on the opposite side of every rivet.
Step 14- Important Final Touches