To setup cms setting, Chapter 3.9.8 – AVer ExpressGo User Manual
Page 102
96
3.9.8
To Setup CMS Setting
Next to the Send to CMS check box, click Detail. Click OK to accept the new settings and Cancel to
exit without saving.
CMS: Select the camera to enable/disable sending the video to CMS.
Matrix: Select the camera to enable/disable sending the alarm event video to CMS. The CMS
site need to setup a matrix channel to receive the alarm event from NVR server site(please refer
to CMS manual for detail)
Use transmitting IP address list: Mark to enable and Set specific IP address of CMS server to
receive the alarm video. When this function has enabled, only the IP address of CMS has added
in Allow list can receive the alarm video from the this NVR server. The allow list is up to 32 IP
addresses.