AVer E1008H - Manual (Page 108)

99
6. In Action section, user may now set the alarm action for the system to perform when the
alarm condition is activated.
- Launch E-Map: Display mini E-map on the screen.
- Enlarge Camera View
Switch to only display video in Preview mode from where the alarm is activated.
a. Select the camera from drop down list to specify which camera video to be
enlarged on screen when the alarm is triggered.
b. Retrieve time: set the waiting duration before system switching back to original
Preview mode. If the retrieve time is un-set, the alarm video will keep enlarging
until user switch back to Preview mode manually. The retrieve time range is 0~ 300
seconds.
- Relay Output
Set to enable/disable the relay operation when the alarm is activated and to extend
additional time in second before it stops the relay operation.
a. Beside the Relay Output check box, click Detail.
b. In the Relay Output dialog, select from the available relay list and in the Status
column, set to on/off the relay operation when the alarm is activated.
c. In the Retrieve time check box, you may enable/disable to extend the relay
operation time and set the duration in second (0 ~ 300 seconds).
d. Click OK to exit and accept the setting and Cancel to exit without saving the
setting.