About program shift, Sec. camera activation, About program shift 6-sec. camera activation – Canon EOS 3000 QD User Manual
Page 37
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
P Program AE
1 \
Compose the shot and press the
shutter button completely to take
the picture.
The Difference Between P and D
The
and <0> modes set the same shutter speed and aperture
settings for picture-taking. However, the avaiiabie features are different as
shown below.
O: Settabie by the user.
X;
Not settable by the user.
Feature
P
o
Continuous shooting
o
X
Program shift
o
X
Exposure compensation
o
X
Partial metering/AE lock
o
X
Firing of built-in flash
Fired automatically
X
O
Fired every time
o
X
About Program Shift
In the Program AE mode, you can freely change the shutter speed and
aperture combination (program) set by the camera while the same
exposure value is maintained. This is called program shift.
To shift the program, press the shutter button halfway and turn the <
iSs. >
until the desired shutter speed or aperture is displayed.
• After the picture is taken with the shifted program, the shifted program is
canceled automatically and the original program is restored.
• If the built-in flash is used, the program cannot be shifted.
6-sec. Camera Activation
If the shutter button is pressed halfway and then released without taking a
picture, the shutter speed and aperture will remain displayed on the LCD
panel and in the viewfinder for about 6 seconds.
37