Vermont Casting SDDVRBS - Manual (Page 29)

29
Stardance Direct Vent - Rear Vent Gas Heaters
20012950
CAUTION: Before installation, inspect ember bed
burner for damage. Do not use ember bed if damaged
or cracked. NOTE: Small, shallow surface cracks are
acceptable.
Install the Log Set
�����
���������������
����
Raised Notch
Pin
Pilot Assembly
Raised Notch
LG497
Figure 52
�����
��������
����
Rear Log
LG493
Figure 51
Pilot Cutout
1. Remove the logs from their packaging and inspect
each piece for damage. DO NOT INSTALL DAM-
AGED LOGS.
2. Install the rear log by mating the notch on the bottom
of the log with the raised notch on the back left side
of the ember bed. (Fig. 51) Ensure the cutout in the
right side of the log is sitting around the pilot assem-
bly and pilot is not obstructed. (Fig. 52)