Sony CCD-F33 - Manual (Page 41)

Tape Editing
To edit a home movie tape, you \will need another
VCR or another video camera recorder.
To Edit from Another VCR to this Unit
T-2
While pressing the small button, set the
POWER switch on this unit to VTR and turn on
the other VCR.
Start playback on another VCR.
Slide the • REC switch on this unit.
To Edit from this Unit to Another VCR
1 While pressing the small button, set the
POWER switch on this unit to VTR and turn on
the other VCR.
Slide the EDIT switch on this unit in the
direction of the arrow (ON).
Set the input selector on the VCR to LINE.
Press the
II
button on this unit during playback
at the point where you want to start recording.
Press the record button on the other VCR,
pressing the
II
button.
Release the
II
buttons on both units.
Recording will start.
When the VCR to be used is a stereo type, use
the commercially available audio/video cable (like
Sony VMC-910MS/920MS).
After editing, turn off both units and be sure to
slide the EDIT switch in the reversed direction to
the arrow (OFF).
To cut off an unnecessary portion
Press the II button on the recorder at the beginning
of the unnecessary portion.
Release it where you want to resume recording.
Function of the EDIT switch
Slide this switch in the direction of the arrow (ON)
whenever you edit tapes. Signal loss that results
from tape-to-tape transfer will be reduced, achieving
more accurate signal transfer.
When recording or playing back normally, keep this
switch in the reversed direction to the arrow (OFF).
A^