Before you begin, Operation, To change the ending point – Sony CCD-F33 User Manual
Page 39: Insert recording from the vcr
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Insert Recording from the
VCR
1
fcMIER^
OFf i ^
r VTB
ij"
O I
^
I
ZERO MEM
STBV
^vOlOOII0y
-ZERO MEN;
'Fillin'^
8
You can insert a new scene from the TV or VCR
onto your originally recorded tape.
Before you begin
• Connection is the same as in “Recording a TV
Program”.
• You can see the picture from the VCR in the
viewfinder screen.
Operation
1 While pressing the small button, set the
POWER switch to VTR.
2 Locate the point on the tape where the insert
should end by pressing the or button
during playback.
3 Press the COUNTER RESET button. The
counter is reset to zero.
4 Press the button during playback to
rewind the tape a little further than the point
where the insert should begin.
5 Release the button to resume playback
and press the II button at the insert starting
point.
6 Slide the • REC switch in the arrow direction
to set the unit to recording pause mode.
7 Press the ZERO MEM button.
The insert ending point is stored in the
memory.
8 To start recording, press the II button.
The insert recording will stop automatically near
the counter zero point.
To change the ending point
Press the ZERO MEM button so that the ZERO
MEM indicator disappears, and operate again
from step 2
39