Cabletron Systems 6500 - Manual (Page 42)

2-22 SmartSwitch 6500 User Guide
Using the Console Switch Installation and Setup
If a command requires parameter values, it prompts you for them. For instance, in the example below, show is the
operator, portconfig is the switch-attribute, and 7a1 is the parameter indicating that you want to show configuration
information about port 7A1 .
Smart6500 # show portconfig 7a1
==================================================
Port: 7A1
--------------------------------------------------
Parameter Configured Current
--------------------------------------------------
Sig Type autoConfig pnni10
Sig Role other symmetric
Interface Type private private
Max vpi bits 0 0
Max vci bits 12 12
Max SVC vpci 0 0
Min SVC vci 32 32
Max Vccs 4096 4096
--------------------------------------------------
Other parameters
--------------------------------------------------
Port Admin Status UP
Ilmi Admin Status Enabled AddressRegistration Connectivity
Oper State UP
Trans Type STS-3c
Media Type MMF (S)
Bandwidth 155 MB
Smart6500 #
If you don’t specify parameters with the command, the console prompts you for an input value and provides a default
value displayed in parenthesis. For example, if you enter
show portconfig without specifying a port (as a parameter),
the following appears.
Smart6500 # show portconfig
PortNumber(ALL) :
Port Intf Sig ILMI Trans Media Max Used Oper
Name Type Type State Type Type Bw(MBS) Bw(MBS) State
==============================================================================
CPU private uni40 down STS-3c MMF (S) 155.0 13.87 up
CPU.1 private pnni10 down STS-3c MMF (S) 10.50 0.0 up
7A1 private autoConfig down STS-3c MMF (S) 155.0 0.0 down
7A2 private pnni10 up STS-3c MMF (S) 155.0 1.12 up
7A3 private autoConfig down STS-3c MMF (S) 155.0 0.0 down
7A4 private autoConfig down STS-3c MMF (S) 155.0 0.0 down
7B1 private uni30 up STS-3c MMF (S) 155.0 0.75 up
7B2 private pnni10 up STS-3c MMF (S) 155.0 0.75 up
7B3 private autoConfig down STS-3c MMF (S) 155.0 0.0 down
Smart6500 #
In the example above, the default of “ all ” ports is presented. You can either accept the default by pressing Enter , or
you can enter a specific port number.
Note When you accept the ( all ) default for show , the information displayed is often
abridged.