Cisco 3030 User Manual
Page 67
C-5
Cisco Catalyst Blade Switch 3030 Hardware Installation Guide
OL-8389-01
Appendix C Configuring the Switch with the CLI-Based Setup Program
Accessing the CLI Through the Console Port
The IP address and subnet mask shown here are examples:
Configuring interface Vlan1:
Configure IP on this interface? [yes]:
IP address for this interface [10.0.0.1]:
Subnet mask for this interface [255.255.255.0] : 255.255.255.0
Class A network is 10.0.0.1, 21 subnet bits; mask is /21
Step 9
Enter no when the prompt asks you if you would like to enable the switch as a cluster command switch.
This switch will be a standalone switch.
Would you like to enable as a cluster command switch? [yes/no]: no
Note
Clustering is not supported on the Cisco Catalyst Blade Switch 3030.
You have now completed the initial configuration of the switch, and the switch displays its initial
configuration. An example of the output is shown here:
The following configuration command script was created:
hostname switch1
enable secret 5 $1$cagJ$e4LP91PNazfdADoNAZm6y0
enable password
enable_password
line vty 0 15
password
terminal-password
snmp-server community public
!
!
interface Vlan1
no shutdown
ip address 10.0.0.1 255.255.255.0
!
interface GigabitEthernet0/1
!
interface GigabitEthernet0/2
. . . (output truncated)
interface GigabitEthernet0/16
!
end
Step 10
These choices appear:
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
If you want to save the configuration and use it the next time the switch reboots, save it
in NVRAM by selecting option 2.
Enter your selection [2]:2
Make your selection, and press Return.
Step 11
Disconnect the server chassis serial port or the switch console port from the PC. See the