Cisco 3030 User Manual
Page 34
2-6
Cisco Catalyst Blade Switch 3030 Hardware Installation Guide
OL-8389-01
Chapter 2 Switch Installation
Installing the Switch Module into the Server Chassis
Installing the Switch Module into the Server Chassis
For a description of the switch module, see the
“Features” section on page 1-1
.
Follow these steps to install the switch module into the server chassis:
Step 1
Obtain and make note of this information from your network administrator before you begin the switch
module installation:
•
Switch IP address
•
Subnet mask (IP netmask)
•
Default gateway (router)
•
Enable secret password (encrypted)
•
Enable password (not encrypted)
•
Telnet password
•
SNMP community strings (optional)
Step 2
Select a chassis I/O module bay in which to install the switch module. Follow the prerequisites listed in
the
“Dell Modular Server Chassis Architecture” section on page 2-5
Step 3
Remove the end-cap (blank plug) from the selected bay. Store the end-cap (blank plug) for future use.
Step 4
If you have not already done so, touch the static-protective package that contains the switch module to
an unpainted metal part of the server chassis for at least 2 seconds.
Step 5
Remove the switch module from its static-protective package.
Step 6
Ensure that the release latch on the switch module is in the open position (perpendicular to the module).
(See
Figure 2-2
Switch Module Release Latch in the Open Position
Step 7
Slide the switch module into the appropriate bay until it stops.
143473
11x
12x
13x
14x
15x
16x
Console
11x
12x
13x
14x
15x
16x
CON