Waiting for post to complete, Completing the initial configuration – Cisco 3030 User Manual
Page 39
2-11
Cisco Catalyst Blade Switch 3030 Hardware Installation Guide
OL-8389-01
Chapter 2 Switch Installation
Installing the Switch Module into the Server Chassis
Waiting for POST to Complete
Follow these steps:
Step 1
Wait for the switch to complete POST. It might take several minutes for the switch to complete POST.
Step 2
Verify that POST has completed by confirming that the System Status/ID LED is off and that the
Console LED is solid green or amber. If the switch fails POST because of a misconfiguration or error,
the System Status/ID LED blinks green, and the Console LED is off.
Log into the DRAC/MC console to get more details about the failure mode.
POST errors are usually fatal. Call Cisco Customer Support immediately if your switch fails POST.
See item 4 in
for the location of the System Status/ID LED and the Console LED.
Step 3
Wait for the switch to complete flash initialization. When you see the prompt Press Return to Get
Started!, press Return or Enter.
Step 4
Make sure that the System Status/ID LED on the switch module is off and that the Console LED is green
or amber. This means that the switch module is operating properly.
Step 5
See the
“Completing the Initial Configuration” section on page 2-11
for instructions on setting up and
initially configuring the switch module.
Completing the Initial Configuration
Follow these steps to complete the setup program and to create an initial configuration for the switch.
Note
For information about automatically configuring the switch, see the “Assigning the Switch IP Address
and Default Gateway” chapter in the switch configuration guide.
Step 1
After you have pressed Enter or Return after the prompt to start the initial configuration setup program,
enter yes at these prompts:
Would you like to terminate autoinstall? [yes]: yes
--- System Configuration Dialog ---
Continue with configuration dialog? [yes/no]: yes
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Basic management setup configures only enough connectivity
for management of the system, extended setup will ask you
to configure each interface on the system
Would you like to enter basic management setup? [yes/no]: yes
Configuring global parameters: