Sony MDS-501 - Manual (Page 44)

Labeling Recordings (Title Function)
Entering lowercase letters
1
Keep pressing CAPS until "Selected abc" lights up.
2 Enter the characters.
Entering uppercase letters again
1 Keep pressing CAPS until "Selected ABC" lights up.
2 Enter the characters.
Entering numbers
1
Keep pressing MUM until "Selected 123" lights up.
2 Enter the numbers.
Entering uppercase or lowercase letters again
1 Keep pressing CAPS or NUM until "Selected ABC" or
"Selected abc" lights up.
2 Enter the characters.
To cancel the title function
Press ■.
Changing an existing title
1 To change a track title, press NAME while playing back
the respective track to cause the track name to light up.
To change a disc title, press NAME while the recorder is
stopped to cause the title of the loaded MD to light up.
2 Hold down CLEAR until the current title is erased, then
enter the new title.
3 Press NAME.
Erasing all recorded titles simultaneously (name
erase function)
Use this function to erase all titles on an MD simultaneously.
Note that once erased, titles cannot be recovered.
1 Keep pressing EDIT/NO while the recorder is stopped
until "Name Erase ?" lights up.
To cancel the name erase function
Press ■.
2 Press YES.
"Complete" lights up after all titles have been erased.
I Notes I
If the "Protected" indication lights up
The recorder could not label the disc because the record-protect slot
on the disc is open. Label the disc after closing the slot.
When "TOC" flashes in the display window
Do not jog the recorder or pull out the power cord. After the
recorder updates the contents of the recording, "TOC" lights up. If
You've made any changes to the MD, 'TOC" lights up. If you press
— EJECT or POWER at this lime, TOC" flashes as the actual
contents of the MD are updated.
44