If you entered the wrong character, Press name again, 1 press name while the recorder is stopped – Sony MDS-501 User Manual
Page 43
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Labeling a track with the remote
commander
Use the following procedure to label a track with the remote
commander.
1
.
4
cp cp qp qp
Op Qp cp
cp
op
(aOtd n
2
3
Keep pressing NAME while playing back,
pausing or recording the track to be
labeled.
A flashing cursor appears.
I
name
I
'ffs'
« •
• r • • ts
«1 tt IS M «S
N 17 tl
Enter one character at a time.
cpcpqs^cp
flP C]3 Qp
Cp QD
^9 ^p ^P
^P CD
aabOl
Entering the letter "D"
r\
■ffs'
4 •
• r • • »
11 It IS M IS
IS 17 IS
Repeat step 2 until you have entered the
entire title.
Sl#
4 S
DIflR'iw
_______
« « N 14 »
IS 17 IS
If you entered the wrong character
Press or ►► to move the flashing cursor under
the character to be corrected.
Press CLEAR to erase the incorrect character, then
enter the correct letter.
Press NAME again.
When the labeling procedure has been completed,
the entered title appears on the left side of the
display window.
|NA^
DIPRV
4 S
• r 4 • IS
11 IS • 14 IS
IS 17 IS
Labeling an MD with the remote
commander
After inserting the MD to be labeled, follow the procedure
below to label a disc with the remote commander.
1 Press NAME while the recorder is stopped.
2 Repeat steps 2 to 4 of "Labeling a track with
the remote commander" on this page.
43