Tomei Powered EXHAUST MANIFOLD Ver.2 - Manual (Page 7)

KIT CONTENTS
Below are the kit contents with the quantity noted in brackets ().
REQUIRED TOOLS
Below are the minimal tools required for the installation.
・ General Service Maintenance Tools ・ Official Service Manual
・Torque Wrench ・ Water Coolant (LLC)
CAUTION!
■ This product is designed to be used for off road competition purposes.This product may not be road
legal in your country so please check with your local authorities prior to use on general public roads.
■ This product is to be fitted by an experienced professional in a fully equipped workshop.
■ This product was designed specifically for the engine specified. If the attempt was made to use this product's)
on another engine other than specified then you will risk of damaging the related parts in this kit and/or
the engine that it is used with.
■ If the incorrect tools are used then you risk possible injury or damage to the equipment, product(s)
hazards and or vehicle. Please always work in a safe environment to avoid any health and/or safety.
WARNING!
■ The installation should be done when the engine and engine bay is cold.
■ Always check that all required parts are fitted before starting the car to avoid any fire & safety risks.
7
Exhaust Manifolds (Right/Left)
Heat Sheild
Pl
ate （1）
Heat Sheild
Sheet （1） Heat Sheild Tube
（1）
Tie Wrap （10）
Gasket A（2） ※Between Head & Manifold
Gasket B（2）
※Between Head
& Catalytic Converter
Flange Bolt M10×1.5(2)
Flange Nut M10×1.5(2)
Heater Pipe Gasket（1）
O-ring（1）
Sticker （2）
Bolt Smooth Paste（1）