Caution, Warning, Modifications – Tomei Powered SR22KIT/SR22 FORGED FULL COUNTER CRANKSHAFT User Manual
Page 7

CAUTION
■ This product is to be fitted by an experienced professional in a fully equipped workshop.
■ This product is to be fitted with the correct tools, protective & safety equipment. Failure to do so can
lead to possible work hazards.
■ Use the Nissan Workshop Service Manual for reference, in conjunction with the Piston Kit
Manual that is supplied with this kit during assembly.
■ You will be required to do additional modifications to correct any areas which will cause interference
with the kit after it is installed.
■ This product was specifically designed for the vehicle application as stated above. This is not designed
and may not be suitable for other cars/engines other than stated in this manual. If this product/kit is
installed on any other vehicles/engines it may damage this product and /or the engine /vehicle that it is
fitted to.
■ This product is designed to be used for performance use. You will need to check all other parts that will
be used with the assembly to be sure they are all in excellent condition. Failure to do so will risk this
product and engine when it is used at high engine speeds and at high power outputs. Attention to details
and precision assembly is a must for maximum results.
■ Check for any signs of oil and fluid leakages before driving the vehicle.
■ Upgrading other performance areas of the car is a must after installing this kit. Upgrading and making
suitable adjustments to the suspension and brakes will be required to cope with the new power output of
this engine.
WARNING
With the extended length of the stroker kits rotating assembly, there will be certain areas where some
points of the new rotating assembly will make contact. These points of interference will need to be
addressed to allow free movement of the new stroker kits SR22 Crankshaft and Conrods.
7
Machine/ grind about 1mm-1.5mm off the sections, where it is required to allow the free flow movement
of the SR22 stroker kit rotating assembly.
※ Basic assembly and adjustment notes are available in the "Piston Kit Manual". More detailed
information is available in the Nissan workshop service manual.
【MODIFICATIONS】
① Conrod Small End
③ 8 Points under the cylinders
④ Conrod Bolts (all 8)
⑥ Four points on the main bearing beam
(exhaust side)
② Engine Block Oil Line
All 4 Spots
⑤ The lower side of cylinder No.1.
The opposite side of the alternator
bracket.
⑦ Baffle Plate No.1
4 points on the upper return part.
③
7