Compaq MP1200 - Manual (Page 63)

8–8 Compaq iPAQ Microportable Projector MP1200 User’s Guide
Troubleshooting
Image size is too small or too large. 1. Adjust the digital zoom or move
the camera until the image is the
desired size.
2. The projector may be set to display
in the center of the display area
without any expansion. To change
the setting, access the on-screen
display menu, select A/V & HDTV
Control, select HDTV/Video, then
select how the image should be
shown in the display area. Refer to
Chapter 3, “Using the On-Screen
Display Menu,” for more information.
The image is upside down or a
mirror image is displayed. The projector has been set for operation
in rear screen mode or ceiling mount
mode. To display the image properly,
access the on-screen display menu,
select Image Control, select Flip Image,
then restore the displayed image to the
correct setting. Refer to Chapter 3,
“Using the On-Screen Display Menu,”
for more information.
The desired source is not
displayed. Press the Source button on top of the
projector to review and select from the
active video sources.
Troubleshooting (Continued)
Problem Solutions
261799-001.book Page 8 Thursday, April 25, 2002 3:13 PM