Compaq MP1200 - Manual (Page 15)

2–4 Compaq iPAQ Microportable Projector MP1200 User’s Guide
Using the Projector
Connecting the Projector to a Compaq iPAQ
Pocket PC
To connect the projector to a Compaq iPAQ Pocket PC, the
Pocket PC must have a male connector adapter and a VGA-out
PC Card with a 15-pin connector.
The VGA-out PC Card with the 15-pin connector is not included
with the Compaq iPAQ Pocket PC. For information on purchasing
the optional VGA-out PC Card, contact your Compaq authorized
dealer or reseller. To locate a reseller near you, refer to the
Worldwide Telephone Numbers booklet that came with your
projector or, to purchase directly from Compaq, refer to the
Compaq website at
http://www.compaq.com/products/iPAQ.
1. Connect one end of the signal cable 1 into the VGA-in
connector on the side of the projector and connect the other
end to the VGA-out PC Card. The VGA-out PC Card may be
inserted into the PC slot on the Compaq Pocket PC before or
after connecting the signal cable.
✎
Be sure the signal cable aligns with the connector. Do not force
the cable onto the connector or you may damage the signal cable
or the projector.
2. Connect one end of the power cord 2 into the side of the
projector, and the other end to an electrical outlet that is
easily accessible and close to the projector.
261799-001.book Page 4 Thursday, April 25, 2002 3:13 PM