Compaq MP1200 - Manual (Page 61)

8–6 Compaq iPAQ Microportable Projector MP1200 User’s Guide
Troubleshooting
Lamp shuts off. 1. If the Standby LED flashes green,
the projector has overheated and
will automatically shut down. Wait
five to ten minutes until the LED
stops flashing and the
Power/Standby button turns amber
before restarting the projector again.
2. A minor power surge may cause the
lamp to shut off. Wait a few minutes,
then turn it back on.
3. When the lamp has reached the end
of its life, the system will
automatically turn off to prevent
possible lamp rupture. Replace the
lamp as described in the “Replacing
the Projector Lamp Module” section
of Chapter 7.
Lamp burns out or makes a
popping sound. When the lamp reaches its end of life, it
will burn out and may make a loud
popping sound. If this happens, the
projector will not turn back on until the
lamp module has been replaced.
Contact your local Compaq authorized
dealer, seller, or reseller to purchase a
replacement lamp module. To replace
the lamp, follow the procedures in the
“Replacing the Projector Lamp Module”
section of Chapter 7.
Troubleshooting (Continued)
Problem Solutions
261799-001.book Page 6 Thursday, April 25, 2002 3:13 PM