Compaq MP1200 - Manual (Page 19)

2–8 Compaq iPAQ Microportable Projector MP1200 User’s Guide
Using the Projector
Adjusting the Projected Image
There are three ways to adjust the projected image:
■ Adjusting the projector height
■ Adjusting the image size
■ Adjusting the projector focus
Adjusting the Projector Height
The projector has a built-in elevator foot that can raise the
projector approximately 1 inch (2.54 cm).
To adjust the height:
1. Raise the projector to the desired display angle, then press the
elevator button 1 to release the elevator foot 2.
2. To lower the display angle, press the elevator button again
and press down on the projector to lower it.
Ä
CAUTION: Failure to press the elevator button before adjusting the
elevator foot can result in damage to the elevator mechanism.
3. Turn the screw on the rear foot 3 to raise and lower the back
side of the projector for balance.
261799-001.book Page 8 Thursday, April 25, 2002 3:13 PM