Compaq MP1200 - Manual (Page 53)

7–4 Compaq iPAQ Microportable Projector MP1200 User’s Guide
Care and Maintenance
Follow these steps to replace the projector lamp module:
1. Turn off the projector by pressing the Power/Standby button on
the top of the projector.
2. Allow the projector to cool down for at least 30 minutes.
Å
WARNING: The lamp assembly operates at a very high temperature. To
reduce the risk of personal injury, allow the projector to cool down for at
least 30 minutes before opening the lamp cover. Never open the lamp
cover while the projector is operating or when the lamp is hot.
3. Disconnect the power cord.
4. Carefully turn the projector upside down.
5. Use a coin or flathead screwdriver to remove the screw 1
from the lamp cover.
6. Lift the lamp cover 2 and pull it out at a 45-degree angle 3.
261799-001.book Page 4 Thursday, April 25, 2002 3:13 PM