Compaq MP1200 - Manual (Page 52)

Care and Maintenance
Compaq iPAQ Microportable Projector MP1200 User’s Guide 7–3
3. If the cloth is dirty or smears the lens, wash the cloth. If the
cloth is still dirty after washing it or the fabric is damaged,
replace it.
✎
Do not use fabric softener when washing a cleaning cloth or
softener sheets when drying the cloth.
Ä
CAUTION: Do not store a cleaning cloth in contact with the lens for a
long time as doing so may contaminate the lens with dye from the cloth.
The cloth can be contaminated if left in the open air.
Replacing the Projector Lamp Module
Å
WARNING: When the lamp reaches its end of life, it may pop or
rupture. To reduce the risk of personal injury, be careful when removing
the lamp cover as broken glass may be present. Never open the lamp
cover while the projector is operating or when the lamp is hot.
The projector will alert you when the lamp approaches its failure
mode or end of life. When the message “Lamp May Fail Soon.
Replacement Suggested” displays on the projection screen, you
should change the lamp as soon as possible. Contact your local
Compaq authorized dealer, seller, or reseller to purchase a spare
lamp or have the lamp changed. To locate a reseller near you,
refer to the Worldwide Telephone Numbers booklet that came
with your projector. You can also purchase a lamp directly
through
http://www.compaq.com/products/projectors.
✎
If the projector is mounted from the ceiling, you may need to take
it down before replacing the lamp module, depending on the
ceiling mount bracket used.
261799-001.book Page 3 Thursday, April 25, 2002 3:13 PM