Compaq MP1200 - Manual (Page 17)

2–6 Compaq iPAQ Microportable Projector MP1200 User’s Guide
Using the Projector
2. Remove the lens cap 1 from the projector by pressing in
on the tabs on either side of the lens cap and pulling it
straight out.
3. Press the Power/Standby button 2 on the top of the projector
and allow the projector to warm up for one to two minutes.
When the projector has warmed up, the Compaq startup
screen displays and the LED on the
Power/Standby button 2
turns green.
4. Power on your source (computer, Pocket PC, VCR, etc.) and
launch the software application being used to display images
on the projection screen. If applicable, press the Function key
on the computer designated for external display.
If there is a long delay between the time the startup screen
displays and the time the software application is launched,
the lamp may shut off and the projector will automatically go
into standby mode. If this happens, press the
Power/Standby
button 2 to power on the lamp.
When the startup screen disappears, the video from the
attached computer displays. If there is no incoming video, the
“No Source Found. Please Check Signal Cable” message will
display on the projection screen.
261799-001.book Page 6 Thursday, April 25, 2002 3:13 PM