Connecting the projector to a notebook computer – Compaq MP1200 User Manual

Page 13

Text mode
Original mode

2–2

Compaq iPAQ Microportable Projector MP1200 User’s Guide

Using the Projector

Connecting the Projector to a Notebook
Computer

1. Connect one end of the projector signal cable into the

VGA-in connector on the side of the projector and the other
end to the DVI connector 1A or the VGA connector 1B on
the notebook computer and tighten the screws.

✎

Be sure the signal cable aligns with the connector. Do not force
the cable onto the connector or you may damage the signal cable
or the projector.

2. Connect one end of the power cord 2 into the side of the

projector, and the other end to an electrical outlet that is
easily accessible and close to the projector.

261799-001.book Page 2 Thursday, April 25, 2002 3:13 PM