The keyboard or, System board, Removing the system board – Dell XPS 600 User Manual
Page 62
Removing and Installing Parts: Dell XPS 600 Service Manual
parts0.htm[4/10/2014 9:50:52 PM]
NOTICE:
Ensure that the heat sink is correctly seated and secure.
8. Reinstall the retention module clips.
9. Lower the airflow shroud over the heat sink.
10. Reconnect the two cooling fan power cables to the CPU FAN1 and CPU FAN2 connectors on the system board (see
").
11. Reconnect the power cable to the POWER12V connector on the system board (see "
").
12. Close the computer cover.
NOTICE:
To connect a network cable, first plug the cable into the network port or device and then plug it into the
computer.
13. Connect your computer and devices to electrical outlets, and turn them on.
System Board
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the
System Information Guide.
NOTICE:
The system board and metal tray are connected and are removed as one piece.
Removing the System Board
1. Follow the procedures in "
."